THE POWER TO KEEP YOU MOVING
Proud Sponsor of
|
THE POWER TO KEEP YOU MOVING
Proud Sponsor of
|
|
|
Engine Builds For Blaster
Blaster +4mm Stroker, Big Bore Kit 220cc-260cc High Compression Includes: +4mm stroke hot rods crank shaft & bearings Big bore piston 69-72mm with rings, clips & pin Mill out head with high compression dome Sleeve Cylinder Gaskets & Seals Removal, installation, tuning & labor $1,400.00
Blaster Big Bore Kit 210cc-240cc High Compression Includes: Big bore piston 69-72mm & rings, clips, & pin Mill out head with high compression dome Sleeve cylinder Gaskets Removal, installation, tuning & labor $800.00
Blaster +4mm Stroker Kit 210cc-240cc High Compression Includes: +4mm stroke hot rods crank shaft & bearings Wiseco piston 66-68.25mm & rings, clips, & pin Mill out head with high compression dome Bore cylinder Gaskets & seals Removal, installation, tuning & labor $1,000.00
Blaster Stock Stroke Over Bore Kit 200cc-210cc Includes: Stock stroke hot rods crank shaft & bearings Wiseco piston 66-68.25mm & rings, clips,& pin Bore cylinder Gaskets & seals Removal, installation, tuning & labor $875.00
Blaster Top End Kit 200cc-210cc Includes: Wiseco piston 66-68.25mm & rings, clips,& pin Bore cylinder Gaskets Removal, installation, tuning & labor $400.00
** We recommend the following with these builds** CPI pipe Keihin PKW Carb (or at least T.o.r.s. Block off) V-Force 3 Reed or Boyesen Radvalve A reed spacer K&N Filter Dyna Programmable CDI MSD superconductor coil wire and boot Ricky Stator 200w stator w/Adjustable timing plate Oil injection block off Stage 1 + Porting
|
|
Send mail to
jeff@knuckleheadmotorsports.com with
questions or comments about this web site or call 503-413-9971.
|
